ET1455

  • Pitch
    45.5 mm
  • Height
    25 mm
  • Width
    78 mm
  • Bending radius
    52 – 200 mm

Stay variants

Design 030

Frame with lamella crossbars in the outer radius

  • Weight-optimized plastic frame with particularly high torsional rigidity.
  • Swivable slats on one side in any position.

Opening options
outside: Swivable.

more information

Stay variants

Design 040

Frame with lamella crossbars in the inner radius

  • Weight-optimized plastic frame with particularly high torsional rigidity.
  • Swivable slats on one side in any position.

Opening options
inside: Swivable.

more information

Stay variants

Unsupported arrangement

Unsupported arrangement
Dynamics of unsupported arrangement t
[mm]
vmax [m/s] amax [m/s]
10 50 45.5

Installation dimensions unsupported

KR
[mm]		 H
[mm]		 Hz
[mm]		 LB
[mm]		 UB
[mm]
52 140 165 255 116
65 166 191 296 129
95 226 251 390 159
125 286 211 484 189
150 336 361 563 214
180 396 421 657 244
200 436 461 720 264

Load diagram

for unsupported length depending on additional load

Load diagram
  • Intrinsic cable carrier weight qk = 0.75 kg/m with Bi 38 mm.
    For other inner widths the maximum additional load changes.
  • Fixed point offset Lv: For off-center fixed point connections please contact us.

Calculating the cable carrier length

  • Cable carrier length Lk: Lk ≈ LS/2 + LB (Cable carrier length Lk rounded to pitch t)
  • Unsupported length Lf: Lf = LS/2 + t

Gliding arrangement

Gliding arrangement
Dynamics of gliding arrangement t
[mm]
vmax [m/s] amax [m/s2]
2,5 20 45.5
  • For more information on gliding arrangement please contact us.
  • Only design 030 may be used for gliding arrangements.
  • The gliding cable carrier has to be routed in a channel.
    Our engineers will be happy to help with project planning – please contact us.

Calculating the cable carrier length

  • Cable carrier length Lk: Lk ≈ LS/2 + LB (Cable carrier length Lk rounded to pitch t)

End Connectors

One part end connectors – plastic

The plastic end connectors can be connected from above and below. The connection type can be changed by reconnecting the end connector.

One part end connectors – plastic
Bi
[mm]		 BEF
[mm]		 nz
[mm]
78 94 2 x 6
  • Recommended tightening torque: 6 Nm for screws M6 - 8.8
End connectors without strain relief comb

The end connectors are optionally also available without strain relief comb (except Bi 25). Please state when ordering.

Connection variants

Connection variants

Connection point
F – fixed point
M – driver

Connection type
A – threaded joint outside (standard)
I – threaded joint inside
H – threaded joint outside rotated by 90°
K – threaded joint inside rotated by 90°

Subject to change.